...signals over CATx cable up to 100 metres (330 feet), and even farther with the addition of network switches. • Flexible topology with many options • Configure the Agility for point-to-point extension, multicasting, single-target sharing, and K...

...data in a single cable. HDMI is the de facto standard for consumer electronics. HDMI is backward compatible with DVI. Buy only tested cables with the HDMI logo. This guarantees the cable will perform to specification especially because there ...

...of Cat 3 and Cat 4 cables • Category 3 • Category 3 is the performance level for voice and data transmission up to 16 MHz or 10 Mbps, such as 4-Mbps Token Ring and 10BASE-T. • Category 4 • Categroy 4 is the performance level for voice and data ...

...on the use of S/FTP cable to 1000 MHz. It can support 10GBASE-T transmissions. With both types of cable, each twisted pair is enclosed in foil. In S/FTP cable, all four pairs are encased in an overall metal braid. In F/FTP, the four pairs are en...

...money. • Computer cables can only be too short, but never too long. The same applies to networking cables. Sometimes it is just the last meter that is missing, but in many cases some kilometres are missing. A standard 10/100 or 10/100/1000 Cop...

...ratios • Within a CATx cable of a certain length, the individual pairs might have individual different lengths, caused by higher or lower twist ratios. • There are two common cable standards: • One with a 2 + 2 structure (two pairs of approximately...

...cabling is good, solid cable for 100-Mbps LANs. The Category 5 standard has been around since 1991, so it’s well established. You’ll find existing Category 5 installations everywhere. What can Category 5 cable do, and what can’t it do? • If you sti...

...of the most important cable measurements is Near-End Crosstalk (NEXT). It’s signal interference from one pair that adversely affects another pair on the same end. Crosstalk occurs between adjacent wire pairs (“pair-to-pair NEXT”). In addition, all...